Home-made radiator for hard disk.

    Now let’s proceed to fastening to the hard disk:
   Glue them in the same way as the fins, leaving clear space in the middle for hot adhesive. Let it dry up. Now it’s high time to fix the construction with rivets. The fins are fixed by the glue and that’s enough for them, except angle fins and fastening to the HDD. Thus, fix these fins. Drill holes for the rivets; you may buy small rivets or make them of wire. Clinch 2 rivets for a fin (at the ends of the fins). Thus, we need four rivets. Clench both the fins and fastening to the HDD with the rivets.
 

As a result it looks in the following way.

The modding is almost finished. The last thing is to make heat removers for hard disk chip.