Laser cutting for modding – practical suggestions.

   During laser cutting you should take into account one more thing. It is always concealed the same as the hail. It’s thermal action, burning out of paint on the cutting edges. It's not a big problem, but you should be ready to scrape old paint and to repaint the component.
   If you want to cut polished stainless steel, which is covered with film, you should remove this protective covering, otherwise it will stick to heated metal.
 

   Hail effect and paint burning are usual for metals, there is almost no fume on plastics (the temperature of cutting is smaller), or coke can be removed with protection film (organic glass is covered with it) and hail can be easily removed with your nail. But there is one more problem with organics, which is hard to remove. If there is excess of power of cutting beam edge can be carbonized with small bubbles. If you need to cut wooden components, take into account that the edge would be black and burnt.

Good modding to you all from SilentMods.com