Endless emptiness

    Then, you’ll have to make thread bushings and screws. Screw may have thread ì6 or any other, this is not so important; the length of the bushing is 10-12 mm.
    The depth of the tunnel depends directly on the distance between the mirrors. The only limit is the presence of enough space in the cabinet. Assemble the device in accordance with the picture; this is not difficult. I also recommend covering the sides of the cooler in order it doesn’t reflect in the mirror and spoil the effect. Cooler can be covered with overlay and shield grid as it is shown in the picture 14. The finished modding must look like in the last picture. I hope you will be pleased with it.
     The thread bushing was turned on a lathe, but this is not necessary. You may just sort out studs with nice heads.

  Assembly drawing. It’s recommended to lay cardboard washers under the heads to reduce the risk of glass split.

   The fan grid is standard, from a power box. I made the frame from stainless steel.

Good luck to you!

V Afanasjev

I wish everybody good modding, SilentMods.com